DMX Driver, RGB DMX Decoder, Digital Display, 3channels/12V-24V/12A/288W

DMX Decoder & LED Driver 3 Channels LED RGB Controller DC12-24V Constant Voltage Single CH PWM < 4A Model: DE8008
Feature:
1. Meets DMX512/1990
2.256-levels brightness, full-color with driver controls
3. Output 3 channels, MAX 4A per channel. Total current is 12A.
4. Can achieve asynchronous color changes effect under working with controller.
5. Cooperate with control system, can realize rich change effect.
6. With the digital display to show the program.
7. Modularizing and can be matched with different LED module neatly.
8. Custom-made available.

Tech-parameter:
Input: DC12-24V
Output: < 12A
Control channels: 1-3CH Signal
Input: DMX-512/1990 Digital signal
MAX Power: < 288W
Frequence: 5000Hz Work
Temp.: 0~70 The light gray level: 256
Protection grade: IP40
Gross product: 230g
Product size: L160*W47*H22(mm)/
Custom-made

Function Instructions:
1.: Product panel operation instructions, through the digital tube display the address, through the switch control address code, when adjust to the address code of you need, can press lock key and lock the current address code, if in the current state not press the lock key, in 3 seconds the system self-locking address, demand reset address code, first press the unlock key, then set the address code. (in the lock key operation, the third paragraph digital tube will show the corresponding instructions), if in 5 minutes didn't any operation with the switch, so digital tube will close, If want to see the show again, then press the unlock key.
A. Address code Settings: Such as the first DE8008, put into 001, the second is set to 004. A DE8008 accounted for three IP address.
B. With self test procedures, numerical Settings to colorful gradient effect.
2.: DMX input/output terminals. See panel connect correctly.
3.: 4PIN is driver output interface (of altogether anode output driver, with a LED + interface and 3 channels CH1-CH2-CH3-output interface, may meet all kinds of full-color module and monochrome module automatically according to the lamps module load regulation output pulse). 2 PIN is the power input interface (supply the power for decoder itself and decoder with lamps).

DMX-512 control signal connection
1. DMX signal cable is made of twisted pair (line), DMX signal includes positive and negative end, in pressure welding DMX signal line plug should pay special attention to polarity. DMX512 controller output signal positive, signal negative, signal ground with DE8008 input interface corresponding connection.
2. DMX5000 output and DE8008's transmission lines can't be over 300 meters.
3. DMX5000 each interface can with not more than 170 pieces of DE8008. Eight output interface. Through the JBLED FLASH light making software and can with computer on line control. Realize infinite contact the DMX lights.
4. When connected 32 pieces of DE8008, DMX signal must add a signal amplifier RE2000. Cascade can't more than 4 PCS.